蜜桃Av久久精品人人槡_亚洲阿V天堂网2019无码_亚洲精品不卡无码福利在线观看_免费人成网站视频在线观看国内_高潮一区_观看亚洲色欲色欲色欲WWW

歡迎來到東莞市艾維品實業有限公司官網!

東莞市艾維品實業有限公司

專業研發、生產、銷售各種花紋的水轉印膜

全國咨詢熱線

400-0253-888

新聞資訊

新聞中心

當前位置: 首頁 > 新聞中心 > 永康公司新聞

永康水轉印加工技術操作方法

2023-06-02 09:02:52

1. 確定適當水溫 (20 °C – 30°C),水面保持溢流狀態。

Make sure the proper water temperature (20 °C - 30 °C), keep water at overflow state.


2. 保持水表面無活化劑殘留及雜質。

Keep the water surface without activator residues and impurities.


3. 置膜,以適當角度將膜平放于水面(確定膜之正反面,印刷層朝上)

Put the film on the water flatly with the proper angle.( Confirm the film positive & negative, printing side up)


4.配合水溫設定溶解時間,水溫一般為25-30度,溶解時間約為45秒到2分鐘

Set dissolution time with water temperature which is often 25°C-30 °C. The dissolution time is about 45 seconds to 2 minutes.


5.視印刷油墨之厚度,判定噴涂活化劑之時間,油墨層越厚,可在膜尚未完全溶解時,提前噴涂活化劑,讓油墨活化時間加長,而一般作業情況溶解1分鐘左右可噴涂活化劑,待膜成鏡面而平坦擴展(5秒-15秒)即可上膜、轉印。

Spray activator time depends on the thick of printing ink. The thicker the ink layer, spray activator in advance before the film not yet completely dissolved, to make the ink activate time much longer. General operation condition is about 1 minute to dissolve, then spray activator. After flat extension of the film (5 seconds -15 seconds), then put the film to be printed and transferred .


6. 在上膜之前需視加工物之外形或有紋路性,選擇下水角度,以利于空氣排出。

Select water down angle to exhaust air well as the dip items' shape or lines prior to film transfer . 


7. 上膜后,不可立即拿起,應在水中搖晃3-5秒,切斷邊緣之膜,增加紋路咬住被加工物之時間。

Do not take out the work piece immediately after transfer the film. Shake it on the water for 3-5 seconds, to cut the edge's film and increase the lines to bite work piece's time.


8. 活化劑噴涂需以0.8mm*4孔噴槍及可攪拌式壓力操作業,噴涂距離約30cm,空氣壓力適當調整避免花紋脫落,不可有水花產生,必要時水溫可加到35°C, 水槽之水量需作溢, 最后一道水需干凈,沖洗完成需經空氣吹干并經品管修整再入烘烤爐。

Spray activator with 0.8mm * 4 hole spray gun and operate by stirred pressure. Spray distance is about 30cm. Adjust air pressure properly to avoid the film pattern fall off, and water can't be splashed. Add water temperature to 35 °C if necessary. The tank water is overflow and the last water must be clean. After rinse, then dry by oven. 


不同的圖案,必須使用不同的底色,如木紋基本使用棕色、咖啡色、土黃色等,石紋基本使用白色等.

 Different film pattern , different base coat. e.g. Wood grain (often Brown, khaki), Marble grain (often white etc).


近期瀏覽:

contact us

東莞市艾維品實業有限公司

廣東省東莞市樟木頭鎮金河社區濱河路31號

水轉印膜丨水轉印耗材丨水轉印設備

水轉印產品代加工丨水轉印技術支持

水轉印開發、生產、加工、銷售、培訓一條龍服務

contact us

         


         掃一掃 添加微信

SERVICE

聯系人:(董先生)

133-7860-9888

全國熱線

400-0253-888

座機

0769-81723888

0769-87123588

24小時在線客服
主站蜘蛛池模板: 国产又粗又大久久久久久 | 麻豆av网站在线观看 | 男女激烈床震gif动态图免费 | 激情射精爆插热吻无码视频 | 欧美日韩一区二区三区四区 | 成视频在线观看免费观看 | 国产精品无码专区在线播放 | 中文字幕久久波多野结衣AV | 太粗太大弄死我了l毛片 | 色综合伊人色综合网站 | 大乳美女a级三级三级 | 日韩一卡2卡3卡4卡乱码免费网站 | 亚洲人精品亚洲人成在线 | 亚洲一区二区三区精品f | 好大好硬好爽18禁视频 | 久久99精品久久久久久蜜芽 | 色五月激情五月 | 亚洲成人一区二区在线观看 | 国产色婷婷久久99精品91 | 九九热99视频| 国产精品乱码毛片在线人与 | 四虎导航 | 色欲日韩中文无码字幕影院 | 人妻色综合网站 | 亚洲精品爆乳一区二区H | 少妇人体色www网站 最近中文字幕国语免费 | av在线亚洲男人的天堂 | 久久精品2021国产 | 宅男视频免费在线观看视频 | 91在线九色 | 欧美日韩在线精品一区二区三区激情综合 | 国产精品欧美福利久久 | 好大好深好猛好爽视频 | 91欧美精品成人综合在线观看 | 亚洲视频高清不卡在线观看 | 曰本一级黄色片 | 黄色欧美视频 | 亚洲国产精品无码久久一线 | 欧美交A欧美精品喷水 | 欧美人与动性xxxxx杂 | 热久久中文 |